Chelsio Communications Terminator Series Installation And User Manual page 33

Chapter I. Chelsio Unified Wire
Menu Mode
i. Download the tarball specific to your operating system and architecture from
Download Center.
ii. Untar the tarball:
E.g., for RHEL 6.9, untar using the following command:
[root@host~]# tar zxvf <driver_package>-RHEL6.9_x86_64.tar.gz
iii. Change your current working directory to Chelsio Unified Wire package directory
[root@host~]# cd ChelsioUwire-x.x.x.x-<OS>-<arch>
iv. Install Unified Wire:
[root@host~]# ./install.py
v. Select the Installation type as described below. Enter the corresponding number in the Input
field and press Enter.
a. Unified Wire: Install all the drivers in the Unified Wire software package. This option
will not install OFED and drivers built against OFED.
b. Wire Direct Latency: Install Wire Direct Latency drivers needed for Low latency
applications.
c. Custom: Customize the installation. Use this option to install drivers/software and
related components (like OFED 4.8-2) as per the tuning option selected.
d. EXIT: Exit the installer.
The Installation options may vary depending on the Configuration tuning option
Note
selected.
vi. The selected components will now be installed.
vii. Reboot your machine for changes to take effect.
If the installation aborts with the message "Resolve the errors/dependencies
Note
manually and restart the installation", please go through the install.log to resolve
errors/dependencies and then start the installation again.
Chelsio Unified Wire for Linux
Chelsio
33