System Wide Parameters - Chelsio Communications Terminator Series Installation And User Manual

Chapter X. iSCSI PDU Offload Target
Auth_CHAP_ChallengeLength
Auth_CHAP_Policy
The following parameters SHOULD NOT be changed because only one valid value is supported:
DataPDUInOrder
DataSequenceInOrder
ErrorRecoveryLevel
OFMarker
IFMarker
The following parameters can be changed but would not have any effect because they are either
not supported or they are irrelevant:
DefaultTime2Wait
DefaultTime2Retain
OFMarkInt
IFMarkInt
4.11.

System Wide Parameters

The Chelsio Global Entity Settings are system wide parameters that can be controlled through
the configuration file or the use of the command line "
these parameters are described in detail here:
iscsi_login_complete_time
Options: An integer value between 0 and 3600 (seconds). Default value is 300 (seconds).
This is the login timeout check. The parameter controls the maximum time (in seconds) allowed
to the initiator to complete the login phase. If a connection has been in the login phase longer
than the set value, the target will drop the connection.
Value zero turns off this login timeout check.
iscsi_auth_order
Options: "ACL" or "CHAP", defaults to "CHAP"
On an iSCSI target when
perform CHAP first then ACL or perform ACL then CHAP.
ACL: When setting
start of the login phase for an iSCSI normal session: upon receiving the first
iscsi_login_request, the target will check its ACL. If this iSCSI connection does not match any
ACL provisioned, the login attempt will be terminated.
Chelsio Unified Wire for Linux
(support only "Yes")
(support only "Yes")
(support only "0")
(support only "No")
(support only "No")
(not supported)
(not supported)
(irrelevant because OFMarker=No)
(irrelevant because IFMarker=No)
ACL_Enable is set to
iscsi_auth_order=ACL
". The finer points of some of
iscsictl -G
Yes , iscsi_auth_order
, initiator authorization will be performed at the
decides whether to
184