Software/Driver Unloading - Chelsio Communications T5 Installation And User Manual
Lio iscsi target offload driver for linux
Hide thumbs
Also See for T5:
- Installation and user manual (511 pages) ,
- User manual (460 pages) ,
- Installation and user manual (468 pages)
Table of Contents
Advertisement
Chapter 6. Software/Driver Unloading
6. Software/Driver Unloading
To unload the LIO iSCSI Target Offload kernel module, follow the steps mentioned below:
i.
Log out from the initiator.
ii. Run the following command:
[root@host~]# echo 0 >
/sys/kernel/config/target/iscsi/<target_iqn>/tpgt_1/np/<target_ip>\:3260/cxg
bit
Execute the above command for every portal address listening on Chelsio interface.
iii. Unload the driver:
[root@host~]# rmmod cxgbit
Chelsio T5 LIO iSCSI Target Offload Driver for Linux
15
Advertisement
Table of Contents
Need help?
Do you have a question about the T5 and is the answer not in the manual?