Connecting The Ip100 Series; Step 1-Connecting The Nap To A Power Source.16 - Nokia IP100 Series Installation Manual

Connecting the IP100 Series

Step 1—Connecting the NAP to a Power Source
16
To use an IP100 Series NAP you must:
Step 1—Connect the NAP to a power source
Step 2—Connect a console to the NAP
Step 3—Connect the NAP to a network
Plug the power cord that comes with the NAP into the 5-volt DC adapter.
Plug the other end into a 3-wire, grounded power source. Then plug the
adapter into the POWER socket on the rear panel. The POWER LED on
the front panel should display green. Figure 2-3 shows the NAP
connected to a power source.
Figure 2-3. NAP connected to power source
IP100 Series Installation Guide