Changing Bulbs - Mercedes-Benz Sprinter Operating Instructions Manual

Light and vision
90
Switching the interior lighting switch-off delay time
on/off
Multimedia system:
© Settings
4 5 5
Interior Lighting Delay
5
Switch the switch-off delay time on or off.
#
If the function is active, the interior lighting will
switch on automatically when the vehicle is
unlocked or switched off.

Changing bulbs

Instructions for replacing illuminants
& WARNING Risk of burns from hot compo-
nent parts whilst replacing a bulb
Bulbs, lamps and plug connectors can become
very hot during operation.
When replacing a bulb, you could burn yourself
on these component parts.
Allow the component parts to cool down
#
before replacing the bulbs.
Important safety notes
Before changing the bulbs, switch off the vehi-
R
cle's lighting system. This will prevent a short
circuit.
Use only spare bulbs of the same type and with
R
the correct voltage.
Use bulbs only in enclosed lamps that have
R
been designed for them.
Do not use any illuminant that has been drop-
R
ped or has scratches on its glass tube. Other-
wise, the illuminant may explode.
The illuminant may explode under the following
R
conditions:
if it is hot and you touch it
-
if you drop it
-
if you scratch it
-
Stains on the glass tube will reduce the service
R
life of the illuminant. Do not touch the glass
tube with your bare hands. If necessary, clean
the glass tube with alcohol or spirits while it is
cold and wipe it down with a lint-free cloth.
Protect light bulbs from humidity and do not
R
bring them into contact with liquids.
Always ensure the bulbs are firmly secured.
If your vehicle is equipped with LED modules, you
can check this as follows: the light cone will move
from top to bottom and back again when the vehi-
cle starts. For this to work, low beam needs to
have been switched on before the vehicle is star-
ted.
Light
Bulbs and lamps are major elements in vehicle
safety. Therefore, ensure that they are always
working. Have the headlamp setting checked regu-
larly.
If the new light source also does not light up, con-
sult a qualified specialist workshop.
Replacing front light bulbs (vehicles with halogen
headlamps)
▌Overview of illuminant types
You can replace the following light sources.
1
2
3
▌Replacing halogen headlamps
Requirements:
R
R
R
R
Halogen headlamps
High beam/daytime running lights:
H15 55 W/15 W
Low beam/perimeter light: H7 55 W/W 5 W
Turn signal light: 3457 NAK 28 W
Low beam: bulb type H7 55 W
High beam/daytime running lamps: bulb type
H15 55 W/15 W
Perimeter lights: bulb type W 5 W
Turn signal lights: bulb type 3457 NAK 28 W