Installing The Cell Wash Head - Thermo Scientific Wellwash Versa User Manual

Installing the cell wash
Thermo Fisher Scientific
Figure 2–13. Fitting the blank wash head onto the left position of the wash
head arm
7. If you replace the wash head, you must calibrate the wash head.
Refer to "Calibrate current wash head" on page 97.
8. If you change the wash head to another type, first change the wash
head and then calibrate the wash head.
Install the optional 2x8 / 96 (cell wash) wash head properly onto the
head wash head arm (Figure 2–14). Refer to "Installing the wash head(s)" on
page 18.
Note Check that the brown adapters of the 2x8 cell wash head are
inserted (Figure 2–14).
Note When you replace the cell wash head adapters (Figure 2–14 A),
change them both at the same time.
▲
▲
Thermo Scientific Wellwash Versa User Manual
Installation
Setups
21