Well - Thermo Scientific Wellwash Versa User Manual

Menus, Tabs and Parameters
Main menu
64 Thermo Scientific Wellwash Versa User Manual
When you press the
The default wash head setting is set in the Settings menu. When a one-
column wash head (1x8 or 1x12) is used, the blank wash head
should always be on the left of the wash head arm (viewed from the
front).
Select the wash head and plate and press the
"Wash head configuration" on page 84 and "Creating a protocol" on
page 57.
Note Calibrate the wash head(s) if not already calibrated.

Well

You can select the well shape and well offset on the Well row in the
Main menu.
If you change the well shape, check the step parameters afterwards.
When you press the
The following settings are available:
Well bottom – Select the well shape.
●
Different well shapes of strips and plates available are shown in
Figure 6-36. The default well shape format is Flat.
button, the wash head/plate list box appears.
OK
button, the Well type window appears.
OK
button. Refer to
OK
▲
Thermo Fisher Scientific