Table of Contents
Advertisement
8B-20 LIGHTING SYSTEM
Hazard Warning Light Switch Removal and
Installation
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Remove audio unit (if equipped) and center upper garnish
referring to Step2) to 3) of "Information Display Removal and
Installation" in Section 8D.
3) Remove hazard warning light switch (1) from switch case (2)
while releasing the locks (3)
INSTALLATION
Reverse removal procedure for installation.
Hazard Warning Light Switch Inspection
Check the continuity of each switch position.
If any correct continuity is not obtained, replace hazard warning
light switch.
Hazard warning light switch specification
Terminal
Hazard Switch
OFF
ON
Turn Signal and Hazard Warning Light Relay
Removal and Installation
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Remove light control switch combination unit (1) referring to
"Light Control Switch Combination Unit Removal and Instal-
lation" in this section.
3) Remove turn signal and hazard warning light relay (2).
INSTALLATION
Reverse removal procedure for installation.
a
b
c
d
e
f
g
Advertisement
Table of Contents
