Alcatel-Lucent 7750 SR Manual page 839

Description This command configures attributes of a SDP binding on the B-VPLS service.
Parameters sdp-id — Specifies the SDP ID.
vc-id — Specifies the VC ID.
stp
Syntax [no] stp
Context config>service>Vpls>pbb>backbone-vpls
Description This command enables or disable STP through B-VPLS service.
force-qtag-forwarding
Syntax [no] force-qtag-forwarding
Context config>service>vpls ivpls>pbb
config>service>epipe>pbb
Description
This command forces the addition of a IEEE 802.1q tag after the Customer MAC (CMAC) addresses
when the PBB header is built, as it egresses a related BVPLS.
It is used to preserve the dot1q and DE bits from the customer domain when the service delimiting
qtags are stripped when the packet is ingressing a PBB Epipe or an IVPLS. The VLAN value of the
service delimiting QTAG if one exists is used for the corresponding inserted dot1q field. If a service
delimiting QTAG does not exist, then the value of zero is used for all the inserted QTAG bits.
The no form of this command sets default behavior.
Default
disabled
mrp-policy
Syntax [no] mrp-policy
Context config>service>vpls>sap>mrp
config>service>vpls>spoke-sdp>mrp
config>service>vpls>mesh-sdp>mrp
Description
This command instructs MMRP to use the mrp-policy defined in the command to control which
group BMAC attributes will be declares and registered on the egress SAP/Mesh-SDP/Spoke-SDP.
The Group BMACs will be derived from the ISIDs using the procedure used in the PBB solution. The
Group MAC = standard OUI with the last 24 bits being the ISID value. If the policy-name refers to a
non-existing mrp-policy the command should return error. Changes to a mrp-policy are allowed and
applied to the SAP/SDPs under which the policy is referenced.
7750 SR OS Services Guide
Values 1..17407
Values
1..4294967295
VPLS Service Commands
Page 839