Alcatel-Lucent 7750 SR Manual page 841

epipe
Syntax epipe service-id customer customer-id [vpn vpn-id] [vc-switching] [create]
epipe service-id
no epipe service-id
Context config>service
Description
This command configures an Epipe service instance. This command is used to configure a point-to-
point epipe service. An Epipe connects two endpoints defined as Service Access Points (SAPs). Both
SAPs may be defined in one 7750 SR or they may be defined in separate 7750 SR devices connected
over the service provider network. When the endpoint SAPs are separated by the service provider
network, the far end SAP is generalized into a Service Distribution Point (SDP). This SDP describes
a destination 7750 SR and the encapsulation method used to reach it.
No MAC learning or filtering is provided on an Epipe.
When a service is created, the customer keyword and customer-id must be specified and associates
the service with a customer. The customer-id must already exist having been created using the
customer command in the service context. Once a service has been created with a customer
association, it is not possible to edit the customer association. The service must be deleted and
recreated with a new customer association.
Once a service is created, the use of the customer customer-id is optional for navigating into the
service configuration context. Attempting to edit a service with the incorrect customer-id specified
will result in an error.
By default, no epipe services exist until they are explicitly created with this command.
The no form of this command deletes the epipe service instance with the specified service-id. The
service cannot be deleted until the service has been shutdown.
service-id-epipe
service-id — The unique service identification number identifying the service in the service domain.
epipe customer
customer customer-id — Specifies the customer ID number to be associated with the service. This
vpn
vpn vpn-id — Specifies the VPN ID number which allows you to identify virtual private networks
vc-switching — Specifies if the pseudowire switching signalling is used for the spoke SDPs
7750 SR OS Services Guide
This ID must be unique to this service and may not be used for any other service of any type. The
service-id must be the same number used for every 7750 SR on which this service is defined.
Values
1 — 2147483648
parameter is required on service creation and optional for service editing or deleting.
Values
1 — 2147483647
(VPNs) by a VPN ID. If this parameter is not specified, the VPN ID uses the same service ID
number.
Values 1 — 2147483647
Default
null (0)
configured in this service.
VPLS Service Commands
Page 841