Alcatel-Lucent 7750 SR Manual page 831

Syntax mrp
Context config>service>vpls
config>service>vpls>mesh-sdp
config>service>vpls>sap
config>service>vpls>spoke-sdp
Description This command configures Multiple Registration Protocol (MRP) parameters. MRP is valid only
under B-VPLS.
attribute-table-size
Syntax [no] attribute-table-size value
Context config>service>vpls>mrp
Description
This command controls the number of attributes accepted on a per B-VPLS basis. When the limit is
reached, no new attributes will be registered.
If a new lower limit (smaller than the current number of attributes) from a local or dynamic I-VPLS is
being provisioned, a CLI warning will be issued stating that the system is currently beyond the new
limit. The value will be accepted, but any creation of new attributes will be blocked under the
attribute count drops below the new limit; the software will then start enforcing the new limit.
Default
maximum number of attributes
Parameters value — [1-2048] for ESS-6/7/12 or SR-7/SR-12
attribute-table-high-wmark
Syntax [no] attribute-table-high-wmark high-water-mark
Context config>service>vpls>mrp
Description This command specifies the percentage filling level of the MMRP attribute table where logs and traps
are sent.
Default
95%
Parameters high-water-mark — 1%-100%
attribute-table-low-wmark
Syntax [no] attribute-table-low-wmark low-water-mark
Context config>service>vpls>mrp
7750 SR OS Services Guide
[1-1023] for ESS1/SR1/7710
VPLS Service Commands
Page 831