Alcatel-Lucent 7750 SR Manual page 957

Os services guide

Hide thumbs Also See for 7750 SR:

Table of Contents

all-ones — The all-ones keyword following the broadcast parameter specifies the broadcast address

host-ones — The host-ones keyword following the broadcast parameter specifies that the broadcast

igp-inhibit — The optional igp-inhibit parameter signals that the given secondary IP interface

static-arp ip-address ieee-mac-address

no static-arp ip-address

config>service>ies>interface

This command configures a static address resolution protocol (ARP) entry associating a subscriber IP

address with a MAC address for the core router instance. This static ARP appears in the core routing

ARP table. A static ARP can only be configured if it exists on the network attached to the IP

If an entry for a particular IP address already exists and a new MAC address is configured for the IP

address, the existing MAC address will be replaced with the new MAC address.

The no form of the command removes a static ARP entry.

ip-address — Specifies the IP address for the static ARP in IP address dotted decimal notation.

ieee-mac-address — Specifies the 48-bit MAC address for the static ARP in the form

7750 SR OS Services Guide

this parameter to change the broadcast address to all-ones or revert back to a broadcast address of

The broadcast format on an IP interface can be specified when the IP address is assigned or

This parameter does not affect the type of broadcasts that can be received by the IP interface. A

host sending either the local broadcast (all-ones) or the valid subnet broadcast address (host-

ones) will be received by the IP interface. (Default: host-ones)

used by the IP interface for this IP address will be 255.255.255.255, also known as the local

address used by the IP interface for this IP address will be the subnet broadcast address. This is

an IP address that corresponds to the local subnet described by the ip-address and the mask-

length or mask with all the host bits set to binary one. This is the default broadcast address used

by an IP interface.

The broadcast parameter within the address command does not have a negate feature, which is

usually used to revert a parameter to the default value. To change the broadcast type to host-

ones after being changed to all-ones, the address command must be executed with the

broadcast parameter defined.

should not be recognized as a local interface by the running IGP. For OSPF and IS-IS, this means

that the specified secondary IP interfaces will not be injected and used as passive interfaces and

will not be advertised as internal IP interfaces into the IGP's link state database. For RIP, this

means that these secondary IP interfaces will not source RIP updates.

aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee and ff are hexadecimal numbers.

IES Service Configuration Commands