1.12.8.4 Importing the Tip Mounting Position Error
1
Spot Welding Application Using a Motor Gun
1.12 Tip Wear Detection and Wear Compensation (Motor Gun)
.
Teach the following two positions to be the same position.
•
in the job for tip mounting position error detection: the
position short before the dry spot touch motion
– " 1' " in the above explanation
NOTE
•
in the wear detection job: the position short before the
dry spot touch motion
– " 1 " in the above explanation
Also, teach positions short before the movable side tip
detecting motion (" 4 " and " 4' " in the above explanation) to
be the same position.
Operation Procedures
1. Select {SPOT WELDING} on the {Main Menu}.
2. Select {SPOT SUPERVISION}.
1-133
143 of 198