Tentative Setting Of Torque To Pressure Conversion Data - YASKAWA YRC1000 Operator's Manual

1.3.4 Tentative Setting of Torque to Pressure Conversion Data

1 Spot Welding Application Using a Motor Gun
1.3 Setting of Motor Gun
In order to use Motor Auto Tuning function, it is necessary to set the
torque to pressure conversion data of the Gun Condition file tentatively.
Normally, the tentative setting is already set. Therefore, confirm that
pressing can be done correctly by the maximum pressure and half of the
maximum pressure.
If the tentative setting is not set, set the gun motor torque at the maximum
pressure and half of the maximum pressure as shown in the following
procedures.
<Ex. when the maximum pressure is 6000(N)>
Find and set the torques(%) at 6000(N) and 3000(N)
1. Set a value to {THICKNESS FORCE GAUGE} and select "ENABLE" at
{PRESS MEASUREMENT MODE} on the "MANUAL PRESS" window.
1-7
17 of 198