YASKAWA YRC1000 Operator's Manual page 182

1 Spot Welding Application Using a Motor Gun
1.13 Other Functions Using a Motor Gun
• Universal signal can be used to switch to the measure
mode.
• When using the universal signal to switch to the thickness
measure mode, perform the following settings to "THICK-
NESS CHECK MODE SELECT GIN#" on APPLICATION
CONDITION SETTING window.
THICKNESS CHECK MODE SELECT GIN#
0
1 to 2048: Switches to the thickness measure mode while
NOTE
• Note that when "THICKNESS CHECK MODE SELECT
GIN#" on APPLICATION CONDITION SETTING window
is set with other than 0, it is impossible to switch to the
thickness measure mode by using the programming pen-
dant.
• While above universal signal is input, to switch again to
the thickness measure mode after the measure mode is
canceled by one of the operations described in How to
Cancel Thickness Measure Mode , turn off then on the
universal signal.
1-172
: Switches to the thickness measure mode by
using the programming pendant.
the specified universal signal is input.
182 of 198