Figure 3-8: Status Output Connector; Table 3-3: Status Output Pin Assignments - Teledyne T700 Operation Manual

Getting Started
1

Table 3-3: Status Output Pin Assignments

OUTPUT STATUS
# DEFINITION
1 SYSTEM OK
2 POWER OK
3 CAL ACTIVE
4
5 TEMP ALARM
6 PRESS ALARM
7 & 8 Unassigned
D Emitter BUS
(blank)
+ DC POWER
Digital Ground
42
2 3 4 5

Figure 3-8: Status Output Connector

The pin assignments for the Status Outputs are:
On if no faults are present.
On if no faults are present.
On if the calibrator is in GENERATE mode.
DIAG On if the calibrator is in DIAGNOSTIC mode.
On whenever a temperature alarm is active.
On whenever gas pressure alarm is active.
The emitters of the transistors on pins 1 to 8 are bussed together.
(blank) Not Used
+ 5 VDC
The ground level from the calibrator's internal DC power supplies.
Teledyne API – Model T700 Dynamic Dilution Calibrator
STATUS
6 7 8
CONDITION
+
D
06873B DCN6388