Functional Checks - Teledyne T700 Operation Manual

Getting Started

3.4.3. FUNCTIONAL CHECKS

5. After the calibrator's components have warmed up for at least 30 minutes, verify that the
6. Check to ensure that the calibrator is functioning within allowable operating parameters.
7. If your calibrator is operating via Ethernet and your network is running a dynamic host
80
software properly supports any hardware options that are installed.
Appendix C includes a list of test functions viewable from the calibrator's front panel as
well as their expected values. These functions are also useful tools for diagnosing
problems with your calibrator (Section 9.1.2). The enclosed Final Test and Validation
Data sheet (P/N 05731) lists these values before the instrument left the factory.
To view the current values of these parameters press the following button sequence on
the calibrator's front panel. Remember that until the unit has completed its warm-up,
these parameters may not have stabilized.
configuration protocol (DHCP) software package, the Ethernet will automatically
configure its interface with your LAN. However, it is a good idea to check these settings
Teledyne API – Model T700 Dynamic Dilution Calibrator
06873B DCN6388