The Gptps Step - Teledyne T700 Operation Manual

Overview of Operating Modes and Basic Operation

4.3.2.3. The GPTPS Step

Toggle these buttons
to set the NO target
concentration.
MUST be at least 10%
Higher than the Target
O Concentration
3
Toggle these buttons
to set the NO target
concentration.
Should be equal to the
expected NO
2
concentration
Toggle these buttons to
set the target TOTAL
FLOW.
(Default = 2.000 LPM)
Toggle these
buttons to set
DURATION of this
step
134
This step operates and is programmed similarly to the GENERATE GPTPS (see
Section 4.2.4 for information on choosing the correct input values for this step).
At the end of the programming sequence, the T700 firmware will automatically insert a
DURATION step that needs to be defined.
To insert a GPTPS step into a sequence, press:
Starting at the STEPS Submenu
INSERT STEP Submenu
SETUP X.X INSERT STEP: GENERATE
PREV NEXT
Use the PREV and NEXT keys to scroll though the
list of available instructions
SETUP X.X INSERT STEP: GPTPS
PREV NEXT
SETUP X.X GPTPS:0.0 PPB NO
0 0 0
SETUP X.X GPTPS:0.0 PPB O3
0 0 0
SETUP X.X TOTAL FLOW = 2.000 LPM
0 2. 0
SETUP X.X
0 1 0
SETUP X.X 3) DURATION : 10.0 MIN
PREV NEXT
Teledyne API – Model T700 Dynamic Dilution Calibrator
ENTR EXIT
ENTR EXIT
.0 PPB ENTR EXIT
.0 PPB ENTR EXIT
0 0 ENTR EXIT
DURATION: 10.0 MIN
.0 ENTR EXIT
INS DEL EDIT EXIT
EXIT discards the new gas type &
target concentration
ENTR accepts the new gas type &
target concentration
EXIT discards the new gas type &
target concentration
ENTR accepts the new gas type &
target concentration
EXIT discards the new
flow rate
ENTR accepts the
new gas flow rate
EXIT discards the new
setting
ENTR accepts the
new setting
06873B DCN6388