Setting The Repeat Count For A Sequence - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

4.3.1.3. Setting the Repeat Count for a Sequence

This display only appears if there are no sequences currently
programmed into the T700.
OTHERWISE ...
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT
Deletes the sequence shown
in the message field
Scrolls back and forth between
existing sequences
06873B DCN6388
The sequence can be set to repeat a certain number of times, from 1 to 100. It can also
be set to repeat indefinitely by inputting a zero (0) into the REPEAT COUNTER.
To set the REPEAT COUNTER, press:
Make sure that the T700 is
in standby mode.
INS DEL EDIT PRNT EXIT
Edits the sequence shown
in the message field
Toggle these
Enter "0" to cause the sequence to loop indefinitely
Overview of Operating Modes and Basic Operation
STANDBY A-CAL=0.000 LPM
<TST TST> GEN STBY SEQ
SETUP X.X PRIMARY SETUP MENU
GAS SEQ CFG CLK PASS
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT
SETUP X.X END OF SEQUENCES
INS
SETUP X.X NAME:0
SET> EDIT
Continue pressing SET> until ...
SETUP X.X REPEAT COUNT:1
<SET SET> EDIT
SETUP X.X REPEAT COUNT:[0]
0 0 1
button
s to set the repeat count from 1 to 100.
SETUP
MORE EXIT
EXIT
PRNT EXIT
EXIT
EXIT
ENTER EXIT
EXIT discards the
new REPEAT
COUNT
ENTR accepts the
new REPEAT
COUNT
123