Calibrating The Diluent, Cal Gas Optional O; Generator Pressure Sensors - Teledyne T700 Operation Manual

Dynamic dilution calibrator

Hide thumbs Also See for T700:

Table of Contents

Calibration and Verification

7.5.1.1. Calibrating the Diluent, Cal Gas Optional O

1. Turn off the calibrator and open the top cover.

2. For the sensor being calibrated, insert a "T" pneumatic connector at the location

described in Table 7-2 and shown in Figure 7-6 and Figure 7-7.

3. Turn on the calibrator and perform the following steps:

4. Turn OFF the T700.

5. Remove the pressure monitor.

6. Restore the pneumatic lines to their proper connections.

7. Close the calibrator's cover.

Teledyne API – Model T700 Dynamic Dilution Calibrator

06873B DCN6388