Teledyne API – Model T700 Dynamic Dilution Calibrator
Component
AC Power
Connector
EXHAUST
(option)
PHOTOMETER
INLET
(Photometer option)
PHOTOMETER
OUTLET
(Photometer option)
PHOTO ZERO IN
(Photometer option)
PHOTO ZERO OUT
(Photometer option)
DILUENT IN
CALGAS OUT
VENT
CYL 1 thru CYL 4
COM 2
RX TX
RS-232
DCE DTE
CONTROL OUT
STATUS
ANALOG OUT
CONTROL IN
ETHERNET
(optional) USB
Label
power specs
w/
06873B DCN6388
Table 3-2: Rear Panel Description
Cools instrument by pulling ambient air into chassis through side vents and exhausting
Fan
through rear.
Connector for three-prong cord to apply AC power to the analyzer
CAUTION! The cord's power specifications (specs) MUST comply with the
power specs on the calibrator's rear panel Model number label.
Exhaust gas from ozone generator and photometer
CAUTION! Exhaust gas must be vented outside.
Measurement gas input for O
Calibration gas outlet to O
Inlet for photometer Zero Gas
Outlet for photometer Zero Gas
Diluent or zero air gas inlet.
Outlets for calibration gas
Vent port for output manifold
Inlets for up to 4 calibration gases.
Serial communications port for RS-232 or RS-485.
LEDs indicate receive (RX) and transmit (TX) activity on the when blinking.
Serial communications port for RS-232 only.
Switch to select either data terminal equipment or data communication equipment
during RS-232 communication. (Section 5.1)
For outputs to devices such as Programmable Logic Controllers (PLCs).
For outputs to devices such as Programmable Logic Controllers (PLCs).
For voltage or current loop outputs to a strip chart recorder and/or a data logger.
For remotely activating the zero and span calibration modes.
Connector for network or Internet remote communication, using Ethernet cable.
Connector for direct connection to a personal computer, using USB cable.
Identifies the analyzer model number and lists voltage and frequency specifications
Function
photometer
3
photometer
3
Getting Started
37