Overview of Operating Modes and Basic Operation
4.11.6. CONFIGURING LEVEL STATUS BLOCKS
174
There are two STATUS BLOCKS associated with LEADS LEVELS.
BLOCK 1: This block corresponds to the physical CONTROL OUTPUT connections
located on the back panel of the T700 (see Figure 3-4 and Section 3.3.1.5).
BLOCK 2: The second status block does not correspond to any physical output but
is used to communicate status over the serial data port.
To configure the either of the STATUS BLOCKS, press:
Teledyne API – Model T700 Dynamic Dilution Calibrator
06873B DCN6388