Levels; Activating An Existing Level - Teledyne T700 Operation Manual

Teledyne API – Model T700 Dynamic Dilution Calibrator

4.11.3. LEVELS

4.11.4. ACTIVATING AN EXISTING LEVEL

06873B DCN6388
A LEVEL is a combination of several parameters:

An ID number for the LEVEL

An action, (e.g. GENERATE, GPT, GPTPS & MANUAL)

A target concentration value

An output flow rate (if applicable)

Configuration for one or both of two status output blocks.
Up to twenty levels can be defined and used with the T700 using a range of ID numbers
from 0-98. Level 99 is reserved for standby. The levels are not time based and do not
include characteristics such as start time or duration, therefore a single LEVEL can not
switch between different concentration levels and flow rates.
concentration outputs must be programmed into separate LEVELs which are then
individually started and stopped either by an operator at the calibrator's front panel or
through a serial data operation over the RS-232 or Ethernet ports.
To activate an existing defined LEVEL, press:
Overview of Operating Modes and Basic Operation
Separate flow and
167