Interactive Mode; Remote Control Via A Terminal Emulation Program; Help Commands In Interactive Mode; Figure 6-1: Apicom Remote Control Program Interface - Teledyne T700 Operation Manual

Remote Operation

6.2. INTERACTIVE MODE

6.2.1. REMOTE CONTROL VIA A TERMINAL EMULATION PROGRAM

6.2.1.1. Help Commands in Interactive Mode

190

Figure 6-1: APICOM Remote Control Program Interface

Interactive mode is used with a terminal emulation programs or a "dumb" computer
terminal.
Start a terminal emulation program such as HyperTerminal. All configuration
commands must be created following a strict syntax or be pasted in from an existing text
file, which was edited offline and then uploaded through a specific transfer procedure.
The commands that are used to operate the analyzer in this mode are listed in Table 6-1.

Table 6-1: Terminal Mode Software Commands

COMMAND
Control-T
Control-C
CR
(carriage return)
Teledyne API – Model T700 Dynamic Dilution Calibrator
Function
Switches the calibrator to terminal mode
(echo, edit). If mode flags 1 & 2 are OFF,
the interface can be used in interactive
mode with a terminal emulation program.
Switches the calibrator to computer mode
(no echo, no edit).
A carriage return is required after each
command line is typed into the
terminal/computer. The command will not
06873B DCN6388