Turning O; Generator Calibration Points On / Off - Teledyne T700 Operation Manual

Calibration and Verification

7.4.2.4. Turning O

3
STANDBY
Make sure that the T700 is
in standby mode.
<TST
SETUP X.X
GAS
SETUP X.X
COMM FLOW
SETUP X.X
8
Toggle these buttons to
enter the correct
PASSWORD
DIAG
PREV
216

Generator Calibration Points ON / OFF

To enable or disable an existing calibration point, press:
A-CAL=0.000 LPM
TST> GEN STBY SEQ
PRIMARY SETUP MENU
SEQ CFG CLK PASS MORE
SECONDARY SETUP MENU
VA DIAG
ENTER PASSWORD
1 8 ENTR
SIGNAL I/O
NEXT ENTR
Toggle this button to turn
the point ON / OFF
Teledyne API – Model T700 Dynamic Dilution Calibrator
SETUP
EXIT
EXIT
Continue pressing NEXT until ...
DIAG O3 GEN CALIBRATION
EXIT
PREV NEXT
DIAG O3 GEN CALIBRATION
CAL PNTS
EXIT
DIAG O3GEN 1) 500 MV, 5.0 MIN, ON
PREV NEXT
Continue pressing PREV & NEXT until your
reach the point to be turned ON/OFF
DIAG O3GEN 8) 1500 MV, 5.0 MIN, ON
PREV NEXT
DIAG O3GEN CAL. POINT DRIVE:0 MV
<SET SET> EDIT
Continue pressing SET> until ...
DIAG O3GEN CAL. POINT ENABLELD:ON
<SET SET> EDIT
DIAG O3GEN CAL. POINT ENABLELD:ON
ON
ENTR EXIT
EXIT
INS DEL EDIT PRNT EXIT
INS DEL EDIT PRNT EXIT
EXIT
EXIT
EXIT discards
ENTR EXIT
the new setting
ENTR accepts
the new setting
06873B DCN6388