Subaru Legacy 2002 Service Manual page 328

B: INSTALLATION
1) Install front cushion rubbers.
Tightening torque:
34 N·m (3.5 kgf-m, 25.3 ft-lb)
2) Install engine onto transmission.
(1) Position engine in engine compartment and
align it with transmission.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil level gauge,
etc.
(2) Apply a small amount of grease to spline of
main shaft. (MT model)
3) Tighten bolts which hold upper side of transmis-
sion to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
4) Remove lifting device and wire ropes.
5) Remove garage jack.
ENGINE ASSEMBLY
S173079A11
B2M3391
B3M2044
B2M3391
ME-39
6) Install pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
7) Remove ST from torque converter clutch case.
(AT model)
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing ST.
ST 498277200 STOPPER SET
8) Install starter. <Ref. to SC-6, INSTALLATION,
Starter.>
9) Install torque converter clutch onto drive plate.
(AT model)
(1) Tighten bolts which hold torque converter
clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
CAUTION:
Be careful not to drop bolts into torque con-
verter clutch housing.
ST 499977300 CRANK PULLEY WRENCH
(2000 cc model)
ST 499977100 CRANK PULLEY WRENCH
(2500 cc model)
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog plug onto service hole.
10) Install power steering pump on bracket.
Mechanical
H3M1839A
S2M0207