Subaru Legacy 2002 Service Manual page 341

Mechanical
(3) With a 2 mm (0.08 in) dia. stopper pin or a
2 mm (0.08 in) (nominal) dia. hex bar wrench
inserted into the stopper pin hole in the cylinder,
secure the adjuster rod.
2) Install automatic belt tension adjuster assem-
bly.
Tightening torque:
39 N·m (4.0 kgf-m, 28.9 ft-lb)
3) Install belt idler (No. 1).
Tightening torque:
39 N·m (4.0 kgf-m, 28.9 ft-lb)
2. TIMING BELT
S173099A1102
1) Preparation for installation of automatic belt
tension adjuster assembly. <Ref. to ME-51, AUTO-
MATIC BELT TENSION ADJUSTER ASSEMBLY
AND BELT IDLER, INSTALLATION, Timing Belt
Assembly.>
2) Installation of timing belt
TIMING BELT ASSEMBLY
ST1 499207100 CAMSHAFT SPROCKET
ST2 499207400 CAMSHAFT SPROCKET
H2M2383A
CAUTION:
Ensure belt's rotating direction is correct.
H2M2384
3) Install belt idler No. 2.
Tightening torque:
4) Install belt idler (No. 2).
Tightening torque:
B2M2596
ME-52
(1) Turn camshaft sprocket No. 2 using ST1,
and turn camshaft sprocket No. 1 using ST2 so
that their alignment marks (A) come to top posi-
tions.
WRENCH
WRENCH
(2) While aligning alignment mark on timing
belt (B) with marks on sprockets (A), position
timing belt properly.
39 N·m (4.0 kgf-m, 28.9 ft-lb)
39 N·m (4.0 kgf-m, 28.9 ft-lb)
B2M2602B
S2M2312A
S2M1008