Subaru Legacy 2002 Service Manual page 330

12) Tighten nuts which install front cushion rubber
onto crossmember.
Tightening torque:
85 N·m (8.7 kgf-m, 63 ft-lb)
CAUTION:
Make sure the front cushion rubber mounting
bolts (A) and locator (B) are securely installed.
13) Install front and center exhaust pipe.
<Ref. to EX-6, INSTALLATION, Front Exhaust
Pipe.> and <Ref.
INSTALLATION, Front Exhaust Pipe.>
14) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
15) Connect the following connectors.
(1) Engine ground terminals
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Oxygen sensor connector (With catalytic
converter)
(4) Alternator connector and terminal
(5) A/C compressor connectors
(6) Power steering pressure switch
16) Connect the following cables.
(1) Accelerator cable
(2) Cruise control cables (With cruise control)
CAUTION:
After connecting each cable, adjust them.
17) Install air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
ENGINE ASSEMBLY
B2M3880A
to EX(w/oOBD)-6,
ME-41
18) Install A/C pressure hoses.
<Ref. to AC-42, INSTALLATION, Flexible Hose.>
NOTE:
Use new O-rings.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
19) Install radiator to vehicle. <Ref. to CO-22,
INSTALLATION, Radiator.>
20) Install V-belt cover.
21) Install air intake duct and air cleaner case.
<Ref. to IN-7, INSTALLATION, Air Intake Duct.>
and <Ref. to IN-6, INSTALLATION, Air Cleaner
Case.>
22) Install under cover.
23) Install battery in the vehicle, and connect
cables.
24) Fill engine coolant.
<Ref. to CO-13, FILLING OF ENGINE COOLANT,
REPLACEMENT, Engine Coolant.>
25) Check ATF level and correct if necessary. (AT
model)
<Ref. to AT-9, Automatic Transmission Fluid.>
26) Charge A/C system with refrigerant.
<Ref. to AC-23, OPERATION, Refrigerant Charg-
ing Procedure.>
27) Remove front hood stay, and close front hood.
28) Take off the vehicle from lift arms.
C: INSPECTION
1) Make sure pipes and hoses are installed cor-
rectly.
Mechanical
B2M3385
B2M3401
S173079A10