IFM Electronic Ecomat Mobile Series System Manual page 22

Configurations
POUs in the root directory
PLC_CYCLE
PDM_CYCLE_MS
PLC_PRG
Structure of the visualisations in the templates
(Only for PDM)
The visualisations are structured in folders as follows:
Folder
START_PAGE
__MAIN_MENUES
____MAIN_MENUE_1
______DISPLAY_SETUP
________1_DISPLAY_SETUP1
__________1_SOFTWARE_VERSION
__________2_BRIGHTNESS
__________3_SET_RTC
In the templates we have organised the image numbers in steps of 10. This way you can switch into
different language versions of the visualisations by means of an image number offset.
22
ifm System Manual ecomatmobile
Description
for Controller,
CAN operation with layer 2 or as master or slave:
Determines the cycle time of the PLC in the unit.
for PDM,
CAN operation with layer 2 or as master or slave:
Determines the cycle time of the PLC in the unit.
for Controller and PDM,
CAN operation with layer 2 or as master or slave:
Main program This is where further program elements are included.
Image no.
P00001
P00010
P65000
P65010
P65020
P65030
SmartController (CR2500) V05
Description contents
Setting / display of...
- node ID
- CAN baud rate
- status
- GuardErrorNode
- PLC cycle time
Menu screen:
- Display setup
Menu screen:
- Software version
- brightness / contrast
- display / set real-time clock
Display of the software version.
Adjustment of brightness / contrast
Display / set real-time clock
Set up programming system