IFM Electronic Ecomat Mobile Series System Manual page 21

Configurations
POUs in the folder
CONTROL_CR10nn
PDM_TO_PLC
RT_SOFT_KEYS
SELECT_PAGE
POUs in the folder
PDM_DISPLAY_SETTINGS
CHANGE_BRIGHTNESS
DISPLAY_SETTINGS
READ_SOFTWARE_VERS
ifm System Manual ecomatmobile
Description
for PDM,
CAN operation with layer 2:
Organises the communication from the PDM to the Controller:
- monitors the transmission time,
- transmits control data for image change, input values etc.
Contains the following parameterised POUs:
- CAN_1_TRANSMIT,
- CAN_1_RECEIVE.
for PDM,
CAN operation with layer 2 or as master or slave:
Provides the rising edges of the (virtual) key signals in the PDM. As many variables as
desired (as virtual keys) can be mapped on the global variable SoftKeyGlobal when e.g.
a program part is to be copied from a CR1050 to a CR1055. It contains only the keys
F1...F3:
→ For the virtual keys F4...F6 variables have to be created. Map these self-created
variables on the global softkeys. Work only with the global softkeys in the program.
Advantage: Adaptations are only required in one place.
for PDM,
CAN operation with layer 2 or as master or slave:
Organises the selection of the visualisations.
Contains the following parameterised POUs:
- RT_SOFT_KEYS (→ up).
Description
for PDM,
CAN operation with layer 2 or as master or slave:
Organises brightness / contrast of the monitor.
for PDM,
CAN operation with layer 2 or as master or slave:
Sets the real-time clock, controls brightness / contrast of the monitor, shows the
software version.
Contains the following parameterised POUs:
- CHANGE_BRIGHTNESS (→ up),
- CurTimeEx (→ 3S),
- PDM_SET_RTC,
- READ_SOFTWARE_VERS (→ down),
(→ 3S).
for PDM,
CAN operation with layer 2 or as master or slave:
Shows the software version.
Contains the following parameterised POUs:
- DEVICE_KERNEL_VERSION1,
- DEVICE_RUNTIME_VERSION,
- LEFT (→ 3S).
SmartController (CR2500) V05
Set up programming system
21