IFM Electronic Ecomat Mobile Series System Manual page 15

Configurations
Activating the PLC configuration
During the configuration of the programming system (→ previous section) automatically also the PLC
configuration was carried out.
The point [PLC Configuration] is reached via the tab [Resources]. Double-click on [PLC Configuration]
to open the corresponding window.
► Click on the tab [Resources] in CoDeSys
► Double-click on [PLC Configuration] in the left column.
> Display of the current PLC configuration (→ following figure):
Based on the configuration the following is available in the program environment for the user:
•
All important system and error flags
Depending on the application and the application program, these flags must be processed and
evaluated. Access is made via their symbolic names.
•
The structure of the inputs and outputs
These can be directly symbolically designated (highly recommended!) in the window [PLC
Configuration] (example → figure below) and are available in the whole project as [Global
Variables].
ifm System Manual ecomatmobile
®
SmartController (CR2500) V05
:
Set up programming system
15