Ejecting Cartridges Through A Standard Cap In Manual Mode - StorageTek 4410 Hardware Operator's Manual

CAUTION:
ROBOT/MEDIA DAMAGE. Make sure that ENTER appears on the display
before you open the PCAP.
5. Open the PCAP.
6. If Remove Cartridges appears on the display, remove the cartridge that was
not accepted by the robot.
7. If you must place more cartridges in the PCAP, repeat step
step
8. Close the empty PCAP. The PCAP returns to an empty state.
To discontinue this operation:
9. At the console, type the appropriate command to drain the PCAP and make it
available for other work.
10. Remove any cartridge left in the PCAP.
11. Close the PCAP door. Locked appears on the display.
Ejecting Cartridges through a Standard CAP in Manual
Mode
Use the eject command to eject cartridges from an LSM. Refer to the appropriate
software manual for the command syntax and console messages.
1. Type the eject command at the console.
The CAP EJECT indicator on the CAP panel turns on
The robot places cartridges into the CAP until all specified cartridges are in the CAP
or all CAP cells are filled.
A message appears on the console.
The CAP LOCKED indicator turns off.
CAUTION:
ROBOT/MEDIA DAMAGE. Make sure that the CAP LOCKED indicator is
off before you open the CAP.
2. Open the CAP door.
3. Remove all cartridges. Do not leave cartridges in the CAP.
4. Close the CAP door.
5. If more cartridges need to be ejected, the robot continues filling the CAP. Wait until
the CAP door is unlocked and repeat step
The eject operation ends automatically when all specified cartridges have been ejected.
9206
6 as many times as necessary.
Eleventh Edition
LSM Automatic Mode
3 on page 3-11
(Figure 2-3 on page
2 through step 4 as necessary.
through
2-11).
3-13