Transport Condition Messages - StorageTek 4410 Hardware Operator's Manual

Cartridge Drive Operator Panel
Table 2-6. 4xxx CD Operator Panel—Inside LSM (Continued)
Figure 2-7
Label
Item
5
REWIND
6
UNLOAD
7
READY *
*
Make sure that the READY indicator is on for each transport before you leave the LSM to
Note:
return the system to automatic mode.

Transport Condition Messages

The message display shows transport condition changes.
and their meanings.
2-24
Type Function
•
Momentary switch
In a manual mode LSM, press this switch
and the
change the intensity of the transport
message display. See
Transport/Drive Display" in Chapter 3,
"Operating an ACS."
Rewinds tape to BOT and ejects cartridge
for removal by operator, if the
ready
In a manual mode LSM, press this switch
Momentary switch
and the
change the intensity of the transport
message display. See
Transport/Drive Display" in Chapter 3,
"Operating an ACS."
Switch: Press this switch to set and reset
the
switch is set, the transport can read and
write data from and to tape, and the
REWIND
disabled.
Momentary switch
Green LED When the ready state is not set, either the
transport is prevented from becoming ready,
or, if it is ready, it exits the ready state when
it finishes the record it is processing.
Indicator: On when
switch is in Ready position.
Eleventh Edition
Press (if the
Ready/Not-ready
in Not-ready position) to rewind tape to
the beginning of the tape (BOT). Press
again and hold down for several
seconds to reset any hold off-load and
reset the display.
switch for two seconds to
UNLOAD
"Resetting a
switch is in Not-ready position.
switch for two seconds to
REWIND
"Resetting a
switch. When the
Ready Enable
and push buttons are
UNLOAD
Ready/Not-Ready
Table 2-7 lists these messages
switch is
Ready/Not-
Ready
9206