When The Pcap Is In Manual Mode - StorageTek 4410 Hardware Operator's Manual

LSM Automatic Mode

When the PCAP is in Manual Mode

Use the appropriate enter command to enter cartridges into a PCAP when it is in manual
mode.
1. Type the enter command at the console.
Enter and Load Cartridges appear on the display.
A message appears on the console.
The PCAP door unlocks.
CAUTION:
ROBOT/MEDIA DAMAGE. Make sure that Enter appears on the display
before you open the PCAP.
WARNING:
PHYSICAL INJURY. To prevent contact with the robot and possible injury
to yourself, do not try to reach beyond the PCAP into the LSM.
ATTENTION:
Pour éviter de heurter le robot et éviter d'être blessé, ne pas essayer
d'aller au-delà du PCAP dans le LSM.
WARNUNG:
Um eine Berührung des Roboters und mögliche Verletzungen zu
verhindern, nicht versuchen, hinter das CAP in das LSM zu reichen.
AVVERTENZA:
Per evitare il contatto con il robot e possibili lesioni, non tentare di
allungare le braccia nell'LSM oltre il PCAP.
2. Open the PCAP door by pulling down on the paddle handle PCAP latch
on page
3. Place the cartridges into the PCAP cell
so that the customer label is on top and the VOLSER is facing you.
CAUTION:
MEDIA DAMAGE. Do not slam the door. The robot cannot retrieve a
cartridge if it falls out of the PCAP onto the floor.
4. Close the PCAP door. Locked appears on the display.
The robot scans the PCAP and stores the cartridge if its label is readable.
The PCAP unlocks when the robot has removed the cartridge from the PCAP.
3-12
3-8).
Eleventh Edition
(Figure 3-4 on page 3-9). Insert the cartridge
(Figure 3-3
9206