StorageTek 4410 Hardware Operator's Manual page 74

LSM Automatic Mode
CAUTION:
SYSTEM INTERRUPTION. Do not skip any cells in a given row. The robot
stops scanning the CAP cells when it finds the first empty cell.
CARTRIDGES THAT ARE PLACED AFTER AN EMPTY CELL ARE NOT
ENTERED.
3. Place the cartridges into the CAP cells
so that the customer label is on the left, and the volume serial ID (VOLSER) label
faces toward you.
Fill the top row of storage cells from left to right, then the middle row from left to
right, and then the bottom row, until you have inserted all the cartridges or filled
the CAP.
CAUTION:
MEDIA DAMAGE. Do not slam the CAP door. The robot cannot recover
cartridges that fall on the floor.
4. Close the CAP door. The CAP LOCKED indicator on the CAP panel turns on
(Figure 2-3 on page
Note: The CAP ENTER indicator remains lit until the enter operation is ended by
The robot scans the CAP and stores all cartridges with readable labels inside the
LSM. Cartridges with unreadable labels are left in the CAP. The CAP unlocks when
the robot has removed all readable cartridges from the CAP.
CAUTION:
ROBOT/MEDIA DAMAGE. Make sure that the CAP LOCKED indicator is
OFF before you open the CAP.
5. Open the CAP.
If any cartridges were not accepted by the robot, a message to this effect appears on
the console.
6. If you must place more cartridges in the CAP, repeat steps
necessary.
7. Close the empty CAP. The CAP returns to an enter state.
To discontinue this operation:
8. At the console, type the command to drain the CAP and make it available for other
work. Refer to the appropriate software manual.
9. The CAP ENTER indicator turns off.
10. Remove any cartridges that are left in the CAP.
11. Close the CAP door. The CAP LOCKED indicator turns on.
3-6
2-11).
a console command.
Eleventh Edition
(Figure 3-2 on page 3-5). Insert the cartridges
3 through 5 as often as
9206