Controlling The Transport/Drive Display Intensity - StorageTek 4410 Hardware Operator's Manual

AVVERTENZA:
I trasportatori vuoti effettuano movimenti di elevazione durante i test
automatici. Stare lontano dall'apertura di inserimento della cartuccia
fino a quando il display non diventa attivo.
Prima di inserire una cartuccia in un trasportatore in un LSM a modalità
manuale, accertarsi che sul pannello del display del trasportatore siano
visualizzati StorageTek, o un asterisco, o le informazioni relative al
volume/cella.
2. When the transport is empty and the READY indicator is lit, hold down the
REWIND
message display and clears the Hold Off Load condition. Repeat this step for every
non-busy transport that does not have an active display.
Note: Allocated transports display the cartridge VOLSER and the cell location. An

Controlling the Transport/Drive Display Intensity

Note: A T9x40 tape drive display has no intensity adjustment.
Use the
When you hold down these two switches at the same time, the display dims to the next
level of intensity every 2 seconds (100 percent, 50 percent, 25 percent, and off),
continuing to cycle until you release the switches. The brightness remains at the level that
exists when you release the two switches.
Note: The drive must be in the
9206
switch for about 4 seconds
asterisk appears if the transport is not allocated to a mount request.
and
REWIND UNLOAD
Eleventh Edition
(Figure 3-21 on page
switches to control the intensity of the message display.
state for these switches to function in this way.
READY
LSM Manual Mode
3-44). This resets the
*
3-43