Raising And Lowering The Robot - StorageTek 4410 Hardware Operator's Manual

CAUTION:
To prevent damage to robotic components, follow these steps:
• Do not touch any shiny polished surfaces. Body oils can destroy the
lubrication on these surfaces.
• Do not touch any lubricated parts.
• Push or pull the robotics carriage only as shown in the following
figures.
• The robot should move freely. Do not force the robot if movement is
restricted.

Raising and Lowering the Robot

WARNING:
ELECTRICAL SHOCK. Using extreme caution, make sure that your hand
is placed at a point where no electrical parts are exposed.
ATTENTION:
Faire preuve de prudence et s'assurer que les mains ne touchent pas les
composants électriques apparents.
WARNUNG:
Mit besonderer Vorsicht sicherstellen, daß die Hand nicht an einer Stelle
aufliegt, wo stromführende Teile freiliegen.
AVVERTENZA:
Facendo particolare attenzione, verificare non vi siano parti elettriche
esposte nei punti in cui si appoggiano le mani.
If you need to raise or lower the robot, gently pull down or push up by placing your hand
under the Z arm as shown in
on page 3-29
9206
Figure 3-10 on page 3-28
for the 9310 LSM.
Eleventh Edition
LSM Manual Mode
for the 4410 LSM or Figure 3-11
3-27