Enhanced Cap Display Panel - StorageTek 4410 Hardware Operator's Manual

Enhanced CAP Display Panel

The enhanced CAP contains 81 cells that allow you to enter or eject up to 81 cartridges
from the library without your having to enter the LSM.
The CAP consists of a one-cell priority CAP (PCAP) and two doors that have 40 cells
each.
The display panel above the PCAP on the LSM access door displays CAP and PCAP
status, number and location of cartridges in the CAPs, and error messages
page 2-14).
The panel is divided into three sections–PCAP on the left, CAP 1 in the middle, and
CAP 0 on the right.
The upper portion of each section shows requests for operator intervention and error
messages. Data messages, such as Load Cartridges and Remove Cartridges,
appear in reverse screen color. During the idle state of the PCAP, the StorageTek logo
and Nearline appears.
The middle portion of each section shows CAP status, such as Locked, Enter, and
Eject.
The lower portion of each section shows CAP access interrupt status, such as Door
Open, and the number of cartridges in the device.
The LED push-button switch on the left-hand side below the PCAP display allows you
to restore the display if it has gone blank. When the CAP or PCAP has been inactive for
10 minutes, the display goes blank and the green LED in the switch lights. The display
remains blank until you press the switch, a host request for CAP interaction occurs, or a
CAP/PCAP door open or close operation is sensed.
The LED switch is enabled with LMU firmware Release 3.4. For firmware releases before
Release 3.4, one of two conditions exist:
• On earlier display panels, the display dims and displays reverse video.
• On later display panels, the display goes to reverse video but does not dim.
After Release 3.4, all displays go blank
switch, the display returns if a door open/close sense occurs or a host request for
CAP/PCAP interaction occurs.
9206
(Figure 2-4 on page
Eleventh Edition
Enhanced CAP Display Panel
(Figure 2-4 on
2-14). In the absence of a
2-13