LSM Manual Mode
LSM Manual Mode
When the LSM is in manual mode, the robot is disabled, and you must enter the LSM to
mount and dismount cartridges in the cartridge drives. Manual operations include:
•
Determining when the LSM is not in Automatic Mode
•
Placing the LSM in Manual Mode
•
Entering the LSM
•
Moving the Robot
•
Removing a Cartridge from 4410 Robot Fingers
Robot Fingers
•
Resetting a Transport/Drive Display
•
Locating a Cartridge in the LSM
•
Mounting a Cartridge
Determining when the LSM is not in Automatic Mode
The following conditions indicate when an LSM is not functioning in automatic mode:
•
The LSM access door is open.
•
The robot does not automatically mount and dismount cartridges.
•
A console message informs you that an LSM is not ready, indicating a problem has
been detected in the LSM. The message identifies the LSM and provides a code for
the failure.
Displaying LSM Status
If you suspect that the LSM is not functioning in automatic mode, type a command at the
system console to display the status of the LSM. Refer to the appropriate software
manual for the command syntax and console messages. The status display indicates if the
LSM is not functioning in automatic mode.
Dual LMU Environment
ACS requests cannot effectively be automated if all stations are offline to the LMU, or if
all online station paths are not working. In a dual LMU environment, if all online station
paths to the master LMU are not working, use the appropriate switch command to move
the work load to the standby LMU.
3-16
or
Eleventh Edition
Removing a Cartridge from 9310
9206