Table of Contents
Advertisement
Relay function (2.8.1.4.)
Sets the control algorithm used to trip the relay.
Index
Options
Altered by
Note
All relay ON/OFF points must be referenced from Empty (2.2.4.) (Page 170) (bottom of the
vessel), regardless of Sensor Mode (2.1.3.) (Page 163) selection.
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
Relay
See chart below
Preset applications (2.8.1.3.) (Page 194)
Parameter reference
8.6 Setup (2.)
195
Advertisement
Table of Contents
Troubleshooting
