Siemens HydroRanger 200 HMI Operating Instructions Manual page 60

Commissioning
6.4 PROGRAM mode
Changing a numeric value
1. Navigate to the desired parameter.
2. When selected, the current value is displayed.
3. Press RIGHT arrow
4. Use LEFT
5. As each digit is highlighted (selected), use the UP
or decrease the digit respectively.
6. While decimal point is selected, use UP
position.
7. To escape without saving your changes, press LEFT
highlighted. Press LEFT arrow
when new parameter value is correct, press RIGHT arrow
highlighted.
8. Press RIGHT arrow
displays the new selection. Review for accuracy.
①
②
③
58
to open Edit mode. The cursor position is highlighted.
and RIGHT arrow
to accept the new value. The LCD returns to parameter view and
Parameter name
Parameter number
Current value
to move cursor to digit position you wish to change.
and DOWN arrow
and DOWN arrow
arrow continually until ESC is
again to escape without saving changes. Otherwise,
Operating Instructions, 06/2018, A5E36281317-AC
to increase
to shift decimal
continually until OK is
HydroRanger 200 HMI