Siemens HydroRanger 200 HMI Operating Instructions Manual page 198

Parameter reference
8.6 Setup (2.)
Control
Alarm
General
Flow
Pump
Control
196
Type
*OFF
Level
Low Low Alarm
Low Alarm
High Alarm
High High Alarm
In-bounds
Out-of-bounds
Rate of Change
Temperature
LOE
Cable Fault
Totalizer
Flow Sampler
Fixed Duty Assist
Fixed Duty Backup
Alternate Duty Assist
Alternate Duty Backup
Service Ratio Duty Assist
Service Ratio Duty Backup
First In First Out
Flush Valve
Communication
Relay control
Relay set off, no action (preset).
Based on level setpoints ON and OFF.
When level enters the range between ON and
OFF setpoints.
When level exits the range between ON and
OFF setpoints.
Based on rate setpoints ON and OFF.
Based on temperature setpoints ON and OFF.
Loss of echo; when echo is lost.
When the circuit to a transducer is opened.
Every 10 units [Mantissa (2.10.2.2.)
y
(Page 213) - Relay Duration (2.10.2.4.)
(Page 215)]
Every y x 10 units [Mantissa (2.10.2.2.)
2
(Page 213) - Relay Duration (2.10.2.4.)
(Page 215)] or time duration [Relay Interval
Setpoint (2.10.2.6.) (Page 215)]
At fixed ON and OFF setpoints and allows
multiple pumps to run or for rake control.
At fixed ON and OFF setpoints and allows only
one pump to run.
At rotating ON and OFF setpoints and allows
multiple pumps to run.
At rotating ON and OFF setpoints and allows
only one pump to run.
On service ratio at ON and OFF setpoints and
allows multiple pumps to run.
On service ratio at ON and OFF setpoints and
allows only one pump to run.
As Alternate Duty Assist, resets the relay from
staggered OFF setpoints.
Used to control a pump flushing device based
on Flush Systems [Flush pump (2.10.3.2.)
(Page 216) to Flush duration (2.10.3.5.)
(Page 217)].
Based on input from external communications.
For more information, see Modbus register
map (Page 328).
Operating Instructions, 06/2018, A5E36281317-AC
HydroRanger 200 HMI