Siemens HydroRanger 200 HMI Operating Instructions Manual page 79

Flow exponent
(Primary Measuring Device (Page 240) = Exponential devices (Page 240))
The exponent for the flow calculation formula.
Values
Flowrate units
(Primary Measuring Device (Page 240) = Rectangular Flume BS-3680 (Page 240) or Thin
Plate V-Notch Weir BS-3680 (Page 240))
The units used for flow calculations.
Note
Shown only when 2.13.2. Primary Measuring Device (Page 240)= Rectangular Flume BS-
36806 or Thin Plate V-Notch Weir BS-36807.
Index
Options
V-notch angle
(Primary Measuring Device (Page 240) = Thin Plate V-Notch Weir BS-3680 (Page 240))
The V-Notch angle used in the flow calculation formula.
Values
Use this parameter if the Primary Measuring Device is directly supported. The dimensions
required for each PMD vary.
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
Range: -999.000 ... 9999.000
Default: 1.550
Single-point model
Global
Ratiometric
Primary Measuring Device
(2.13.2.) (Page 240) = all
Absolute
Primary Measuring Device
(2.13.2.) (Page 240) =
Rectangular Flume
BS-3680 or Thin Plate V-
Notch Weir BS-3680 only)
Range: 25.000 ... 95.000
Default: 25.000
Dual-point model
Transducer
*Ratiometric calculation
L/S (Liters/second)
M /H (Cubic meters/hour)
3
M /D (Cubic meters/day)
3
FT /S (Cubic feet/second)
3
IMPGAL/MIN (Gallons/minute – Imperial)
MIMPGAL/D (Million gallons/day – Imperial)
GAL/MIN (Gallons/minute – U.S.)
MUSGAL/D (Million gallons/day – U.S.)
Commissioning
6.5 Quick Start Wizards
77