Siemens HydroRanger 200 HMI Operating Instructions Manual page 219

Flush cycles (2.10.3.3.)
Sets the number of pump cycles requiring flush control.
Index
Values
Related
If three flush cycles are required after every ten pump cycles, then:
Flush Interval (2.10.3.4.) (Page 217) = 10
Flush Cycles (2.10.3.3.) = 3
Flush interval (2.10.3.4.)
Sets the number of pump cycles before flush control is enabled.
Index
Values
Related
To start a new flush cycle every ten times the pumps are run, set this to 10.
Flush duration (2.10.3.5.)
Sets the length of time for each flush cycle that the flush control is active.
Index
Values
Related
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
Single-point model
Global
Range: 0 ... 34464
Preset: 0
Relay Function (2.8.1.4.) (Page 195) = Flush Valve
Single-point model
Global
Range: 0 ... 37856
Preset: 0
Relay Function (2.8.1.4.) (Page 195) = Flush Valve
Single-point model
Global
Range: 0.000 ... 9999 seconds
Preset: 0.000 seconds
Relay Function (2.8.1.4.) (Page 195) = Flush Valve
Parameter reference
Dual-point model
Relay
Dual-point model
Relay
Dual-point model
Relay
8.6 Setup (2.)
217