Siemens HydroRanger 200 HMI Operating Instructions Manual page 67

Response rate
Sets the reaction speed of the device to measurement changes in the target range.
Note
• Any changes made to Fill rate/minute (2.3.2.) (Page 173), Empty rate/minute (2.3.3.)
(Page 173), or Response rate (2.3.4.) (Page 174) parameters following the completion of
the wizard will supersede the Response Rate setting.
• Response Rate always displays in meters per minute (m/min).
Index
Options
Factory setting
Use a setting just faster than the maximum filling or emptying rate (whichever is greater).
Slower settings provide higher accuracy, faster settings allow for more rapid level
fluctuations.
Configure another measurement point
Gives option to configure more measurement points or end the wizard
Note
This is available on the dual-point model only.
Options
End of QS Level Wizard
Note
For QS to be successful, all changes must be applied.
Options
To transfer Quick Start values to the device and return to PROGRAM menu, press DOWN
arrow
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
Transducer
Slow (0.1 m/min)
*Medium (1.0 m/min)
Fast (10.0 m/min)
Medium (1.0 m/min)
Yes
No
BACK, CANCEL, FINISH
Display returns to Quick Start (1.1.) menu when Quick Start is successfully com-
pleted or cancelled. If CANCEL is selected, no changes are written to the device.
(Finish). Then press LEFT arrow
Returns to the Measurement Point menu
Completes the Quick Start Level configuration
three times to return to Measurement mode.
Commissioning
6.5 Quick Start Wizards
65