Index Types - Siemens HydroRanger 200 HMI Operating Instructions Manual

8.4

Index types

Indexes are set in each sub-menu by one or more selector parameters. To view or change a
parameter that applies to a different index, the new index must be set in the selector
parameter first.
Name
Global
Read only
Discrete Input
Echo Profile
Level
mA input
mA output
Comm. Port
Relay
Transducer
The three Level points are
1)
● Transducer 1
● Transducer 2
● The calculated point which can be difference [Sensor mode (2.1.3.) (Page 163) = Dual-
Point Difference] or average [Sensor mode (2.1.3.) (Page 163) = Dual-Point Average].
Level point typically has 1 index in Single- point Mode (standard), and 2 indexes in Dual-
Point Mode (optional). A third index is available in both modes when Operation [Sensor
mode (2.1.3.) (Page 163)] is set for DPD [ Sensor mode (2.1.3.) (Page 163) = Dual-Point
Difference] or DPA [ Sensor mode (2.1.3.) (Page 163) = Dual-Point Average].
The number of indexes available in Single-point Mode (standard) is typically 1, but can be
2)
expanded to 2 if Sensor mode (2.1.3.) (Page 163) is set for DPD [ Sensor mode (2.1.3.)
(Page 163) = Dual-Point Difference] or DPA [ Sensor mode (2.1.3.) (Page 163) = Dual-Point
Average].
In Dual-Point Mode (optional), the number of available indexes is always 2.
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
Description
This parameter applies to the entire device.
This parameter cannot be set, only viewed.
Indexed by discrete input
Indexed by stored echo profile
Indexed by level point
1)
Indexed by mA input
1)
Indexed by mA output
1)
Indexed by communications port
Indexed by relay
Indexed by transducer
2)
Parameter reference
8.4 Index types
# of indexes
n/a
n/a
2
10
1, 2, or 3
1
0 or 2
2
6
1 or 2
161