Olivetti d-Color MF651 Service Manual page 385

Field Service Ver. 2.0 Jul. 2009
(9) Horizontal Punch (Z-Fold) Position Adjustment
<Use>
• To adjust the position of the punch hole in the main scanning direction when ZU is in use.
• Make the adjustment upon setup of ZU-606.
<Procedure>
B
1. Make a copy sample in the punch mode.
2. Make an adjustment so that the width B is within the following range.
Standard value: B = 12.0 mm
Setting range: -5.0 mm to +5.0 mm (Step = 0.1 mm)
3. Call the Administrator Settings to the screen.
4. Touch [System Settings]
Punch (Z-Fold) Position Adjustment].
5. Make the setting using [+] or [-].
To make width B greater: Enter the Value of [+]
To make width B smaller: Enter the Value of [-]
6. Touch [OK].
7. Make copies in the punch mode again and check that the punch hole positions have
been adjusted properly.
Y110571-1
B
[Expert Adjustment]
Service Manual
B
[Finisher Adjustment]
10. UTILITY
A109F3C502DA
[Horizontal
325