Fs-Fn Adjustment - Punch Vertical Position - Olivetti d-Color MF651 Service Manual

Field Service Ver. 2.0 Jul. 2009
12.16.3

FS-FN adjustment - Punch Vertical Position

A. Use
• Adjusts the vertical position of the punch holes.
B. Procedure
A
1. Make a copy sample in the punch mode.
2. Make an adjustment so that 1/2 of the length A is within the following standard range.
Specifications:
2-4 hole: A=80 ± 0.5 mm (It is not possible to adjust the A value of the distance between
holes.), 1/2 of the vertical length A ± 1.0 mm
2-3 hole (2 hole): A=70 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
2-3 hole (3 hole): A=108 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
SWE4 hole: B1=70 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
SWE4 hole: B2=21 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
Adjustment range: -5.0 mm to +5.0 mm (1 step: 0.1 mm)
3. Call the Service Mode to the screen.
4. Touch [Finisher]
5. Touch the paper size where punch vertical position is adjusted.
6. Look at the copy and adjust the punch vertical position with the [+]/[-] key.
To move the hole position upward: Enter the value of [+]
To move the hole position downward: Enter the value of [-]
7. Press the Reset key.
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
10. Make another set of copy sample and check the amount of deviation (A).
Y110571-1
A
A
A
A
A
[FS-FN adjustment]
Service Manual
A2
A1
A2
[Punch Vertical Position].
12. SERVICE MODE
A11TF3C510DA
A11TF3C501DA
599