Fs-Fn Adjustment - Punch Horizontal Position (Z-Fold) - Olivetti d-Color MF651 Service Manual

Field Service Ver. 2.0 Jul. 2009
12.16.7

FS-FN adjustment - Punch horizontal position (Z-fold)

A. Use
• To adjust the position of the punch hole in the main scanning direction when ZU is in use.
• Make the adjustment upon setup of ZU-606.
B. Procedure
B
1. Make a copy sample in the punch mode.
2. Make an adjustment so that the width B is within the following range.
Standard value: B = 12.0 mm
Setting range: -5.0 mm to +5.0 mm (Step = 0.1 mm)
3. Call the Service Mode to the screen.
4. Touch [Finisher]
5. Make the setting using [+] or [-].
To make width B greater: Enter the Value of [+]
To make width B smaller: Enter the Value of [-]
6. Touch [OK] twice.
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
9. Make copies in the punch mode again and check that the punch hole positions have
been adjusted properly.
12.16.8 FS-FN adjustment - Punch regist adj. (Z-fold)
A. Use
• Adjust the size of the punch resist loop that is applied when ZU operates.
• Make the adjustment upon setup of ZU-606.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher]
3. Set the correction value using the [+]/[-] keys.
Misaligned punched holes: Enter the value of [+]
Wrinkled paper: Enter the value of [-]
Setting range: -16.0 mm to +16.0 mm (Step = 0.1 mm)
4. Touch [OK] twice.
5. Touch [Exit] on the Service Mode screen.
6. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
7. Make copies in the punch mode again and check that the punch hole positions have
been adjusted properly.
Y110571-1
B
[FS-FN adjustment]
[FS-FN adjustment]
Service Manual
B
[Punch horizontal position (Z-fold)].
[Punch regist adj. (Z-fold)].
12. SERVICE MODE
A109F3C502DA
603