Olivetti d-Color MF651 Service Manual page 381

Field Service Ver. 2.0 Jul. 2009
(4) Punch Vertical Position Adjustment
<Use>
• Adjusts the vertical position of the punch holes.
<Procedure>
A
1. Make a copy sample in the punch mode.
2. Make an adjustment so that 1/2 of the length A is within the following standard range.
Specifications:
2-4 hole: A=80 ± 0.5 mm (It is not possible to adjust the A value of the distance between
holes.), 1/2 of the vertical length A ± 1.0 mm
2-3 hole (2 hole): A=70 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
2-3 hole (3 hole): A=108 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
SWE4 hole: B1=70 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
SWE4 hole: B2=21 ± 0.5 mm (It is not possible to adjust the A value of the distance
between holes.), 1/2 of the vertical length A ± 1.0 mm
Adjustment range: -5.0 mm to +5.0 mm (1 step: 0.1 mm)
3. Call the Administrator Settings to the screen.
4. Touch [System Settings]
Vertical Position Adjustment].
5. Touch the paper size where punch vertical position is adjusted.
6. Look at the copy and adjust the punch vertical position with the [+]/[-] key.
To move the hole position upward: Enter the value of [+]
To move the hole position downward: Enter the value of [-]
7. Touch [OK].
8. Make another set of copy sample and check the amount of deviation (A).
Y110571-1
A
A
A
A
A
[Expert Adjustment]
Service Manual
A2
A1
A2
[Finisher Adjustment]
10. UTILITY
A11TF3C510DA
[Punch
A11TF3C501DA
321